Servicing
Repairs
Installations
VAT Reg. No: 864 3840 05
FULL SERVICE PROCEDURE
Remove appliance from its location.
Remove radiants, logs or coals if applicable.
Remove main burner & aggregate bed burner (if fitted).
Remove surface dust & lint from lint arrester & from within primary air ports, venturi & burner.
Check burner for cracks & metal fatigue & clean main burner injector.
Remove pilot assembly, clean burner & injector.
Examine heat exchanger, ignition leads & alignment of electrode.
Refit & check for alignment of radiants, logs or coals.
Where appropriate remove closure plate from fireplace opening & clean debris from void.
Where applicable examine & clean any fan associated with the appliance or flue.
Check ventilation requirements are correct.
Where applicable carry out a flue flow test & check the flue termination is correct.
Refit the appliance checking all disturbed joints for gas soundness using non corrosive LDF.
Relight & test the appliance gas pressure/rate or where necessary both.
Check for a satisfactory flame picture.
Carry out a flue spillage test.
If you have an open flued or flue-
Although this does not negate the need for annual servicing it provides a supplementary line of defence against this odourless & potentially dangerous gas.
